primers?

[Caleb85]

I have a case and a half of WLR and have been using those in my 6mm, 243s, 22250, and anything else for years but a buddy of mine came across a few bricks of 210's and wanted to know if I would by some .are the 210's a better (hotter) (colder) primer then the WLR?

 

[FEENIX]

WLR tends to be hotter than 210.

 

[Caleb85]

WLR tends to be hotter than 210.

Is this good to have ?

 

[Reloader222]

Yes is is good as long as you adjust the load downwards to give you +- the same velocity. It is like turning a old caburator. Start 1gr below and take it up in 0,2gr or 0,3 until you have a match.

 

[Caleb85]

Yes is is good as long as you adjust the load downwards to give you +- the same velocity. It is like turning a old caburator. Start 1gr below and take it up in 0,2gr or 0,3 until you have a match.

Ya I have already got them all tuned to WLR so I think I will just keep them that way.

 

[FEENIX]

Yes is is good as long as you adjust the load downwards to give you +- the same velocity. It is like turning a old caburator. Start 1gr below and take it up in 0,2gr or 0,3 until you have a match.

+1!

 

[Barrelnut]

Plus the case and 1/2 of WRL primers are probably all from the same lot.
It just doesn't get much better than that!

 

[HunterGreen]

I thought federal were hotter, umm

 

[Caleb85]

+1!

WOW 31fps spread in the two!! Thanks for showing that!

 

[Caleb85]

Plus the case and 1/2 of WRL primers are probably all from the same lot.
It just doesn't get much better than that!

Yes they are ..kinda funny story..there only about 4 months old ..a older dealer got a huge shipment of them in to his small store that him and is wife ran, and I just happen to stop by ( been doing business with this guy since I was 8) ..said I could have 500 primers limit. .and when his wife went to the back room for something he shoved two cases at me and said " cash and leave before she comes back!!" Sadly that man passed away two months later.

 

[FEENIX]

WOW 31fps spread in the two!! Thanks for showing that!

... and 1600 PSI more pressure.