Power case trimming

What are you all using for case trimming ? I know there are some cool stuff out there . Post some links ?

I use the Forester trimmer with the drill attachment on it. I can trip 50 pcs of brass in minutes. It works with any drill.
 
I bought the Sinclair power cutter for the Wilson trimmer. It runs with a 3.6 cordless screwdriver. Once you get used to it, it is very accurate. I keep my trimmer in a small vise.
 
over the years I've used 6 different trimmers, The one I use the most is the RCBS power trimmer with 3-way cutters. You have to develop a "system" to properly place the case in the holder to make sure it is aligned properly with the pilot, but easy to figure out and very repeatable. i like the ability to easily adjust not only COL but inside/outside cut as well.
 
Warning! This thread is more than 13 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top