milboltnut
Well-Known Member
I'm sure someone has it.... does it still list info on loading for the M1 Garand? If so what is the minimum and maximum charge for a 150 grain bullet with IMR 4064.
Lyman load manual current edition
- Thread starter milboltnut
- Start date
Help Support Long Range Hunting Forum
Let me check on Load Data. They have some.
milboltnut
Well-Known Member
no 4064 from Hornady, correct. The data you show isn't Lyman?
milboltnut
Well-Known Member
just trying to clarify loading IMR 4064 with bolt action data. When was that article written ?
2018 it's a pdf file and it's for a Garand. See if you can download the pdf file.
The Handloader article was written by John Barsness so you can trust his data.
milboltnut
Well-Known Member
Looks good to me ! Thanks !
Your welcome.
milboltnut
Well-Known Member
the hodgdons data... when was then published? I looked on thier website and see Accurate 4064 description including the Garand but didn't see where to go to get the load data. Just wanted to know for the future to let others know on CMP forum.
Found it under, resources, at the bottom of the page "reference data"
Found it under, resources, at the bottom of the page "reference data"
Last edited:
Source: Aug/Sept 2021 Handloader issue #333.
thomasbangs
Well-Known Member
When I started shooting in Garand matches in 1997, I used IMR 4064 with 150 grain bullets, had success with 48 grains behind both Sierra 150 grain Spitzer point and 150 grain fmj flat base, NRA lists loads for the M-1 with various powders and bullet weights, their listing with IMR 4064 and 150 grain bullets is 50 grains. You will also find that IMR 4895 works very well in the Garand.
