How does a seating die work.

samson

Well-Known Member
Joined
Mar 25, 2003
Messages
295
Location
PA
Does a seater die seat the bullet from the ogive or the tip of the bullet. Maybe it is just me or my equipment but the col is always different(most of the time). I am just using an RCBS seater die (not competition). Do any of you have any suggestions.
 
If you take the die apart, you will answer this question. The seating stem is hollow. The bullet nose fits into this space and then pushed into the neck of the case.

Since this diameter is in a different locations in different bullets, it is possible to seat different brands of bullets to different OAL.

If seating softpoint bullets of the same brand, different OAL also can occur due to the amount of exposed lead. Some noses get knocked shorter.

Measure OAL using the ogive of the bullet. Sinclair makes a neat tool that works with a vernier caliper. simple and accurate. You should find that the OAL measured this way is basically the same. If not, tighten the screws on the seating die and/or change bullets.

Good luck...

Jerry
 
Jerry,
I have the sinclair comparator and am noticing that it is making a mark on the bullet,no matter how lightly i use it. Do you have any suggestions?
 
Take some fine sandpaper and rub the edge of the hole in the comparator. There might be slight burrs from the machining.

Any light marks on the bullet will not affect its performance. Just be consistent.

Jerry
 
Does a seater die seat the bullet from the ogive or the tip of the bullet. Maybe it is just me or my equipment but the col is always different(most of the time). I am just using an RCBS seater die (not competition). Do any of you have any suggestions.

May I suggest that you first find out the exact distance between the ogive to the lans and grooves that give you the greatest performance(tightest group). This will include using the correct combination of brass, powder load, primer and bullet. Using your bullet comparitor in conjuction with the Digital Micrometer and charting your hit patterns will in time give you the correct measures you desire. It is a very specific science. Reloaders all have different opinions about what to use. Increase or decrease your powder loads in increments of 1/10 grain using 5 shot groups to determine what works best for your weapon.
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top