this is a remington 700 bolt and action purchased straight from PTG, with everything done to it. Barrel is a 21inch douglas match barrel, threaded with a blended thread protector. I don't remember the twist, or contour. The pictured group is literally my first handload ever. 3 shot group at 100yrds in 20mph gust. 127lrx, it has shot all factory loads I have tried under 1 inch with a few at .5 inch, I'm sure it will do better with load work up. Under 100rnds on this. The stock is a lvsf stock cut for bdl bottom metal, and bedded. All work was done by the only Smith I use. Joe collier of collier rifles. This is for bare gun, no base, scope, rings.
1600 shipped.
This action was purchased straight from them, they do all the work, trueing,from the PTG Website:
This kit contains the following items:
1 - RH Blued Remington Action for a Short Action Remington 700, Trued
1 - RH PTG bolt with threaded handle, Blueprinted (.705 OD +/- .002)
1 - X-Mark Pro Trigger (Externally Adjustable)
This combo is designed for off-the-shelf factory Remington rifles
Raceway is opened using a PTG guided raceway reamer
A PTG Remington Gen II receiver reamer is used to put I.D to proper diameter and to center line, true receiver lugs, and make receiver lugs and action face parallel.
A PTG piloted tap mandrel is used to chase the threads making them more true to center line.
A PTG bolt is fitted to the action, and the face of the bolt is trued while in the action
1600 shipped.
This action was purchased straight from them, they do all the work, trueing,from the PTG Website:
This kit contains the following items:
1 - RH Blued Remington Action for a Short Action Remington 700, Trued
1 - RH PTG bolt with threaded handle, Blueprinted (.705 OD +/- .002)
1 - X-Mark Pro Trigger (Externally Adjustable)
This combo is designed for off-the-shelf factory Remington rifles
Raceway is opened using a PTG guided raceway reamer
A PTG Remington Gen II receiver reamer is used to put I.D to proper diameter and to center line, true receiver lugs, and make receiver lugs and action face parallel.
A PTG piloted tap mandrel is used to chase the threads making them more true to center line.
A PTG bolt is fitted to the action, and the face of the bolt is trued while in the action
