coating my savage barrel and receiver installed

Travis77

Member
Joined
Dec 16, 2012
Messages
24
What is the best method of getting a barrel and receiver ceracoted? Would it be best to disassemble the barrel/ nut/receiver or could I get by with doing it all assembled? I suppose the only issue I would have if coating it assembled would be being able to remove the nut later for rebarrel. Actually what I am getting is a coating from Polydyne in Houston, but it's similar to ceracote.
 
Warning! This thread is more than 12 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top