Deathly -
Howdy!
I assembled one my own self using hardware store components.
I got a "yoke" ( sorta "y" shaped like a touring fork ) from Grainger, and used a bolt to attach the yoke to the aft sling stud of my CVA Hunter .35 Rem.
I use a hardware store threaded stud of correct length, that is threaded on one end to screw up-into the bottom of the yoke.
The other end is a different thread pitch, and a commodores a threaded plastic knob..... which makes contact w/ the shooting bench top.
I have not recoil tested my mono pod, but it should work for use w/ my reduced load .35 Remington cartridges..... which I'm using for 100yd target work.
I shoot right hand/ right eye dominant, and can use my freed-up lt hand to run the mono pod adjust up/down.
With regards,
357Mag