Breakthrough Suppressor cleaning system

[cornchuck]

Has anyone used the Breakthrough Suppressor Cleaning System? Just wondering how well it works. Mainly how it works on cerakote finish. Will eventually take the cerakote off? I have a DD Enticer STI that needs to be cleaned.

Jason

 

[buckleyboy]

I use it and like it a lot. So far it has not affected the cerakote on two rimfires and three centerfires after 2-ish cleanings. I haven't shot the latest can enough to warrant cleaning it.

Below is a before and after picture of rimfire baffles. (They might not be from the same cleaning session, but still). All I did was soak and rinse. Zero elbow grease or ultrasonic cleaning. If memory serves, there might have been a small bit of stubborn carbon still on one baffle that was removed with a cleaning pick. Soaking it another hour or so probably would have done the trick, too.

 

[Eric H]

I wonder how it would work with brass.

 

[Mike6158]

I used CLR on the internals of my .22 cans but I didn't think the body would do very well in it. I've been thinking about trying Breakthrough. Thanks for the post!

 

[Eric H]

I have the kit but yet to use it. I have some in a small spray bottle that works wonders on the BCGs after taking them apart. They get very dirty when using a can.

 

[Mrvmax]

I have the Bore Tech system that uses a pressure washer but I have not tried it yet. Normally I put the core (which is titanium) in my ultrasonic and clean the tube (which is painted stainless) by hand.