284 Win.
Well-Known Member
- Joined
- Jun 2, 2010
- Messages
- 124
Hello everyone,
I have a 6mm Remington that I am using Winchester brass with and after 2 reloads the brass necks have gotten thicker. The necks have'nt been turned and to me it's not a donut at the neck and should juction. It's 1/3 of the neck thicker starting at the neck shoulder juction and up. I purchased a Pin gage set and .243 pin goes 2/3 down the neck and stops. I have to use a .241 Pin gage to go past the neck and shoulder area. I understand the brass flowing to the neck area but what can I do to stop this from happening. I was thinking of trying out some 7x57 Norma brass and just necking down.
Thanks Anthony
I have a 6mm Remington that I am using Winchester brass with and after 2 reloads the brass necks have gotten thicker. The necks have'nt been turned and to me it's not a donut at the neck and should juction. It's 1/3 of the neck thicker starting at the neck shoulder juction and up. I purchased a Pin gage set and .243 pin goes 2/3 down the neck and stops. I have to use a .241 Pin gage to go past the neck and shoulder area. I understand the brass flowing to the neck area but what can I do to stop this from happening. I was thinking of trying out some 7x57 Norma brass and just necking down.
Thanks Anthony