Hello,
I installed a Tubb Speed Lock in the bolt of my Shultz and Larsen 98 mauser last night. I got the pin and spring from superior shooting. It was an easy install, and all went well.
Except when I tested it to see how much firing pin protrusion there was. It sticks out a long ways. 0.120" As far as my research goes, I should have 0.055" to 0.065".
What is the best method of correcting this??
Thanks alot, Eric
I installed a Tubb Speed Lock in the bolt of my Shultz and Larsen 98 mauser last night. I got the pin and spring from superior shooting. It was an easy install, and all went well.
Except when I tested it to see how much firing pin protrusion there was. It sticks out a long ways. 0.120" As far as my research goes, I should have 0.055" to 0.065".
What is the best method of correcting this??
Thanks alot, Eric