700 BDL to ADL - What parts do I need?

[bowhunthard88]

I just picked up a 1978 short action Remington 700 BDL, I'm looking to put it into a Bell and Carlson Light Varmint stock (same as Remington 700 LVSF), this stock requires an ADL configuration...

What parts do I need for a BDL to ADL conversion, besides a trigger guard and front trigger guard screw?

Thanks for you input!

 

[shortgrass]

Magazine box and the little screw that holds it to the action.

 

[bowhunthard88]

Magazine box and the little screw that holds it to the action.

Is the BDL setup for installation of the ADL box, i.e. the small screw?

 

[shortgrass]

Is the BDL setup for installation of the ADL box, i.e. the small screw?

It used to be all were tapped for that little screw. I don't know about now. Take it outof the stock and look, it's at the rear off-set to one side.

 

[shortgrass]

It's right there, at the end of my scribe.

 

[davkrat]

A trigger guard and front trigger screw. I just got done doing the reverse converting an old ADL to BDL.

 

[Punisher]

My new bdl are all tapped for that little screw. PM me, I think I've got the mag box and screw for a short action.

 

[bowhunthard88]

Thanks all! I have been so busy lately that I still haven't got a chance to yank it out of the stock and check to see if it's threaded for the mag box screw.

Thank you all again!

 

[bowhunthard88]

My rifle is drilled and tapped for the ADL box retainer screw. I'll post pics once I finish this project.

Thanks!