408 Chey Tac brass

ross spagrud

Active Member
Joined
Aug 22, 2001
Messages
30
Location
Winnipeg
It was my understanding that this brass was
currently available from the good folks at
Lost River Ballistics however I have not been
able to contact them via email for some time.

Can anybody shed some light on this.

Thanks in advance.
Ross www.prairiegunworks.com
 
Ross,

We have been to the ShotShow. Just getting back into the swing of things. I had 107 unread messages when I got back, and I was answering some while I was there.

The brass is available. Give us a call.
 
Thanks Warren, do you have a 100 cases you can ship to me tomarrow? These are the new strengthened web version correct? Headstamp and neck dia. 408?

Could you also give the length to top and bottem of shoulder, dia. of shoulder, OAL and angle of shoulder? Will use this for computer load development program.

I'll just be necking them down to .338" and possibly .416" for now.

Ross,

do you have the 338PGW, 416PGW reamer and dies? I'm looking forward to VEL/PSI testing these in 36" barrels.
 
Our experience with the 338 PGW is extremely
limited at this point in time however we
do have the reamer and dies can be had.

The 416 is merely the original 408 necked
up to accept the widely available (although
not necessarily suitable for very long range)
416 bullets. We have done a number of these
and have been generally pleased with the
results however the Chey Tac is without a
doubt the superior long range round.

Ross www.prairiegunworks.com
 
Warning! This thread is more than 23 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top