• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

.338 Lupia Mag and shellholders

FDLT406

Active Member
Joined
Jan 30, 2016
Messages
25
Location
Montana
I am just getting ready to start reloading my .338 Lupia Mag and I am having a problem already.
I have S&B Brass which fits in a RCBS #14 Shellholder
I have Lupia Factory Brass that fits in a RCBS #14 Shellholder
I have HRTRS Brass that occassionaly fits into the RCBS #14 Sometimes loosely, sometimes tight, sometimes not at all.

I bought a RCBS #37 Shellholder and the only brass that fits it is Hornady, which I checked at the LGS.

Someone please have an answer to my problem.

Thanks, Fireman
 
There was some shell holder problems due to the 338 SAMMI specs not being standardized. I can remember if it was a brass or shell holder problem.
Best advice I can give you is, throw all the brass in the scrap bucket but the Lapua, it will save you lots of headaches..
 
Warning! This thread is more than 8 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top