Recent content by argeea

I'm in need of some silver 30mm scope rings for one of my rifles (don't use it much) and was wondering if anyone knows if millet aluminum scope rings (cheap) are ok

thanks for comment!!

read that as springs loose some of their tension, it could affect accuracy

question: would replacing stock firing pin and spring on rem 700 with aftermarket products help shoot better groups?

I can’t part with it. May need it later since I have 3 more of the etronx rifles and lots of primers

may try this and if it works, I will have barrel trimmed

would need recoil lug of .180” tick

I will. thank again shortgrass

yes. number 1 option makes lots of sense. just removed barrel and will take it to smith and have them set it back at least .007. it should then check out ok with nogo gauge. thanks alot for your info!!

replacing bolt on rem 700 22-250. After working on lugs some, bolt engages really good, but bolt closes on nogo gauge. By using some scotch tape on bottom end of nogo gauge, I determined bolt is 5 to 7 thousands too short or chamber too long by same length. Old bolt checked out with go, nogo and...

great video!! lots of info!!

I’m guilty of that. most of my scopes are 16 to 20 power and even one in 25x. planning on using less power in future

wanna get a S & B 8x56 for hunting; see how it works. Hungarian; best price

that is bad ***!!

been reading about famous snipers, specially around wwII. most seem to prefer single power scopes. was it because variable power were not available or some other reason? Would really enjoy output from serious shooters