8
Reaction score
128

Latest activity Postings About Post areas

    • 8
      82nd Bill replied to the thread .25 wsm.
      Phil I totally agree.
    • 8
      82nd Bill replied to the thread .25 wsm.
      One more thing to be caution with is the seating depth. I you have a short action that has a standard-length mag box you may have to...
    • 8
      82nd Bill replied to the thread .25 wsm.
      If you mean on the 25 WSM i would say yes but check out the bullet stabilization on Bergers free chart. I tied 85, g Ballistic tips and...
    • 8
      82nd Bill replied to the thread .25 wsm.
      The necks are not identical to each other after sizing down, not by much but still happens. The Peterson necks grow about 1 to 1.5 K...
    • 8
      82nd Bill replied to the thread .25 wsm.
      I have a 25 WSM that I use for hunting White tail, pigs, mule deer and Yotes. It has a Defiance action with a CF Preferred barrel with a...
    • 8
      Peterson brass is tough and for me does not show pressure signs as obviously as other brass. The issues you are seeing do seem to point...
    • 8
      The muzzle is .670" it's a #3 Bartlein. I've been also kinda wondering about that 3rd shot due to heat, but it never did it before with...
    • 8
      I have experienced the same type of grouping issue with my load development and was getting very frustrated and near angry. I had .3...
    • 8
      82nd Bill replied to the thread Pressure Limits.
      Nicely laid out. But some will read it and forget it. Dumb I have been playing with wild cats for 30+ years, and they will test your...
    • 8
      82nd Bill replied to the thread Opinions on chronograph's.
      Garmin with external battery.
    • 8
      82nd Bill replied to the thread 7mm rem mag.
      are you getting book speed at that load. are you using and loading to the book requirements, i.e. primer and COAL etc. bullet selection?
    • 8
      82nd Bill replied to the thread 7mm rem mag.
      Agreed and a good Chrono is a must have. Like cajun I do not shoot without one. There are way too many reasons for deviations of speed...
    • 8
      82nd Bill replied to the thread 7mm rem mag.
      When you say exact components does that also been the brass? Some brass is thicker than and that means lower charge weight to hit the...
    • 8
      82nd Bill replied to the thread Seating depth changing?.
      Good write up and I agree with this. I would only add that the primer seating can affect CBTO readings. If the primer is seated above...
    • 8
      Back to the original request there are numerous ways to handle recoil. I had shoulder reconstruction, so I understand the need for low...
  • Loading…
  • Loading…
  • Loading…
Back
Top