Need a smith to chamber a barrel

[Justice1327]

I'm looking for a reputable gunsmith that has a 7/6.5 PRC reamer, preferably the one attached, also looking for a 25/6.5 PRC to be cut.

let me know if you are aware of anyone.
Thank you

 

[Justice1327]

Ttt

 

[Sealesniper]

Where are you located. Would be easier to find a local smith. I use Dan Glover of DCGS (sponsor here) and he does a fantastic job, but I don't know if he has those reamers.

 

[Justice1327]

thanks , I know my local gunsmiths. these are very specific Reamers.

 

[tobnpr]

What's the 7/6.5 PRC going to give you that the 7 WSM won't?
Just askin', I'm trying to understand what justifies the expense of custom chambering and resizing reamers/dies for this endeavor...

 

[Justice1327]

There is no good 7 WSM Brass available.
6.5 PRC isn't going anywhere.
I have a 7ss,7 mega and a 280SM. and just want to try it.

 

[WapitiBob]

call Manson and ask for a smiths contact info

 

[Justice1327]

call Manson and ask for a smiths contact info

Already did…they told me they dont keep track of which gunsmith orders a specific reamer. I have contacted short action, customs, GAP, TS customs, and LRI.

 

[FEENIX]

thanks , I know my local gunsmiths. these are very specific Reamers.

Already did…they told me they dont keep track of which gunsmith orders a specific reamer. I have contacted short action, customs, GAP, TS customs, and LRI.

That is the challenge; GS cannot have all the reamers we need/want. You might have to burden the cost and buy the reamers you need/want for your local GS to chamber your barrel. If you purchase the reamers, you might also consider sizing reamers so your GS can make custom dies (including hydraulic forming die) out of die blanks (https://newlonprecision.com/collections/products). Yes, this can be a costly endeavor. This is what I did on my latest build. Good luck!

 

[Eric H]

Buffalo Valley Gunsmithing. He has the 7 PRC according to his reamer list. Does excellent work. http://buffalovalleygunsmithing.com/

 

[FEENIX]

Buffalo Valley Gunsmithing. He has the 7 PRC according to his reamer list. Does excellent work. http://buffalovalleygunsmithing.com/

OP is looking for the shorter PRC case, 7/6.5 PRC.

 

[Eric H]

PACIFIC TOOL AND GAUGE

 

[Schw15]

Patriot valley arms has both reamers

 

[V35BTC]

PACIFIC TOOL AND GAUGE

I hope this is said jokingly-