Tomg
Well-Known Member
Here are the details of the gun build.
The Gun was built by A&A Gunsmithing in Glendale, AZ
Stock is a McMilian A-4 in Olive Drab green, it has a 13.5" length of pull with 2 flush cup mounts on both sides of the butt. also has the adjustable check piece. I had the versa pod mounting stud installed in the end of the forearm.
Action is a Remington 700. I had Lilja Precision build the barrel, it a 28.5 inch barrel with the sendero contour and as you can see it's fluted,
I ordered it in a 1-10 twist. The gun has only fired about 80 rounds and is grouping in the .400 at the moment, I'm sure more time and load development this would be even better.
As far as the work done on the build here's the list of what I had done:
Recessed crown
Install Sako extractor
Open feed rails to accommodate the .721 Firebird
Trigger adjusted to clean crisp 2.5 lbs
Tune and square action
Lap the bolt lugs
Pillar Bed and free float the barrel
Finish in semi gloss Ceracote
Optics are from Hours it is a 4x16x50mm with the H2 retical I have Leupold Mark V rings and bases.
I have 6 boxes of new brass and the RCBS dies.
This whole setup cost me around $ 3,400.00
I will sell this rig with everything for $2,750.00
Gun without optics $2,250.00
Send my you e-mail for photos.
Tom
The Gun was built by A&A Gunsmithing in Glendale, AZ
Stock is a McMilian A-4 in Olive Drab green, it has a 13.5" length of pull with 2 flush cup mounts on both sides of the butt. also has the adjustable check piece. I had the versa pod mounting stud installed in the end of the forearm.
Action is a Remington 700. I had Lilja Precision build the barrel, it a 28.5 inch barrel with the sendero contour and as you can see it's fluted,
I ordered it in a 1-10 twist. The gun has only fired about 80 rounds and is grouping in the .400 at the moment, I'm sure more time and load development this would be even better.
As far as the work done on the build here's the list of what I had done:
Recessed crown
Install Sako extractor
Open feed rails to accommodate the .721 Firebird
Trigger adjusted to clean crisp 2.5 lbs
Tune and square action
Lap the bolt lugs
Pillar Bed and free float the barrel
Finish in semi gloss Ceracote
Optics are from Hours it is a 4x16x50mm with the H2 retical I have Leupold Mark V rings and bases.
I have 6 boxes of new brass and the RCBS dies.
This whole setup cost me around $ 3,400.00
I will sell this rig with everything for $2,750.00
Gun without optics $2,250.00
Send my you e-mail for photos.
Tom
Last edited:
