I built a 20 250 what size bushing should I use
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Which bushing
- Thread starter crystalgayleguy
- Start date
Help Support Long Range Hunting Forum
QuietTexan
Well-Known Member
Most likely somewhere between .224 and .228. With Lapua 22-250 brass I believe I'm at .227 but not 100% sure.
What bullets you going to shoot out of it?
What bullets you going to shoot out of it?
Need to measure your brass
Nosler 32 gr
ShtrRdy
Well-Known Member
It really depends on the brass and your chamber .
Do you have a fired piece of the same brass you can measure the neck diameter?
Do you have a loaded cartridge with the same brass you could measure the neck diameter?
Do you have a fired piece of the same brass you can measure the neck diameter?
Do you have a loaded cartridge with the same brass you could measure the neck diameter?
QuietTexan
Well-Known Member
Wrong thread
Your loaded rounds are probably. 231-.232 with Lapua i hope you have a chamber neck of min..234 if you dont want to turn, .235 would be better.
Non Lapua around .228-229 loaded im guessing which a .232 nk chamber would work
QuietTexan
Well-Known Member
My reamer is a .234 neck, I got it from JGS and that was what they sent me without me specifying a neck diameter so hopefully that's "normal" for the wildcat and what the smith used. (to the extent normalcy exists for such things 
).
).
Last edited:
