On the first run through I've found some screwy things. At 700 yards, the program tracks pretty well with my actual shooting results.
However, if I change from 50 to 100 yard increments, my data changes from the orginal out put data.
Here's my input data
Velocity = 2794
Bullet weight = 168
Bullet BC = .505
Start Distance = 100 yards
Increments = 50 and then change to 100
Altitude 500 and then change to 800
Temp = 85
Scope Height = 2.1
Zero range = 100
wind = 0
Target velocity = 0
Keeping all input data the same except the increments and altitude.
Example: 800 feet altitude at 50 yard increments my 1000 yard Path in inches is -321.4
When I change to 100 yard increments it changes to -317.8
This seems to happen when I use 800 ft elevation. If I go back to say 500 feet it works fine.
Doesn't make any sense to me. The program is also set up for READ ONLY so I can't play with the formulas... yet, just give me some time.
[ 10-05-2004: Message edited by: Jeff In TX ]