Powder for 257 Weatherby

Gpkhill2

Well-Known Member
Joined
Mar 21, 2011
Messages
155
Ok Guys, Thanks in advance. What's everyone's thoughts on powder for a factory Weatherby Vanguard in 257 Weatherby with 110 gr Accubonds. I have RL 23, RL26, H1000 and IMR4530
 
Best accuracy we've seen is with H1000. Going to experiment with RL-26 when weather cools off to conserve the H1000.
 
The 257 Bee is not picky about loads. Any slow burning powder matched to the bullet weight will invariably give good groups and speed. I use what I can get hold of easily and that is 7828SSC. Meters well, top velocities with the heavier bullets I like and 1/2 MOA loads with 5 different bullet makes/weights. Most are so easy to load for they will shoot Weatherby Select factory ammo, at 40 bucks a box, into well less than a half inch for 3 shots. If it wasn't for wanting a different bullet than the 100 grain Hornady Interlock for Elk or Moose (it is a great bullet on Deer and Antelope but a little fragile up close for the heavier game), I would probably just use the factory ammo.
 
Last edited:
Thank You to everyone. I have 6 or 7 pounds of 26 and 3 or 4 pounds of H1000. But my 7 Rem with heavy bullets like 26 also. So i may start with the H1000.
 
May be better options these days but I used this for years in my saami chambered 257 wby
Always start lower....
257 wby brass
100 gr TTSX
FED 215
74.2 gr RL25
3675 fps ..
26 inch bbl 1-10.
 
Warning! This thread is more than 4 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top