I want to put together a fast twist 22-250. The reamer I have is a 0.254 NK and I don't want to neck turn necks if I don't have too. If anyone could get me the loaded neck diameter of their Norma 22-250 brass or the neck wall thickness of it I would appreciate it. Lapua is too thick without turning or else I would just use it. Thanks!
Norma 22-250 Neck Diameter
- Thread starter Jud96
- Start date
Help Support Long Range Hunting Forum
kiwikid
Well-Known Member
The Norma 22.250 cases I have here loaded with Sierra 55 gr GK and 55 gr Norma Oryx measure 0.2497". Lapua cases with the same bullets measure 0.252".
Idaho Lefty
Well-Known Member
- Joined
- Jan 29, 2018
- Messages
- 1,651
Norma Brass, is "usually", a bit thinner at, the Neck than, almost ALL other Brass that, I've used.
Neck thickness of Norma Brass, measure around, .013 to .0135 thick.
Put a Bullet in one and add .004 / .005 to determine Reamer needed .
.254 / .255 should be,.. Fine ! But you "may" have to Turn other manufacturers Brass.
Buy, a couple Hundred Norma's and,.. "Choot em' "
I don't Mix Brass anymore,.. as it "can" cause, "Pressure",.. Problems.
Neck thickness of Norma Brass, measure around, .013 to .0135 thick.
Put a Bullet in one and add .004 / .005 to determine Reamer needed .
.254 / .255 should be,.. Fine ! But you "may" have to Turn other manufacturers Brass.
Buy, a couple Hundred Norma's and,.. "Choot em' "
I don't Mix Brass anymore,.. as it "can" cause, "Pressure",.. Problems.
Last edited:
