• You must be a Supporting Member to create a listing in the Long Range Hunting Marketplace. To read all the rules, click here.

    We offer multiple options to become a Supporting Member here.

K&M Neck Turning Tool Organizer

FNA3G

Well-Known Member
LRH Sponsor
Joined
Jan 16, 2013
Messages
879
If you cant PM me then please email me at [email protected]

Printed up an organizer for my K&M equipment since I don't have a case. Also made a "gripper nut" for the shell holder to make it easier to tighten and loosen the case holder. If anybody could use one. If anybody has any questions or custom requests please let me know.

$33 K&M Turning tool organizer (includes gripper nut and set screws): Has the organizing rack that holds 10 total expanding mandrels or turning pilots in any combination, 7 shell holders, 5 of the threaded cutting bits, the turning tool, expanding mandrel holder and the shellholder tool. Can be mounted to the wall via 2 #8 screws or sat on a shelf.

$18 Gripper Nut Only (with set screws): Gripper nut to fit over the shell holder tool making it easier to remove cases. When installing this on the shell holder tool, align the hex shapes and press the tool all the way into the printed holder making sure its fully seated and then tighten the two set screws until they are just below visible. If excessive resistance is felt while tightening the set screws make sure the tool is fully seated into the printed holder. It is a snug fit and can seem like its full when it is not.
 

Attachments

  • K&M 1 (2).jpg
    K&M 1 (2).jpg
    120.2 KB · Views: 16
  • K&M 2.jpg
    K&M 2.jpg
    71.1 KB · Views: 19
  • K&M 3.jpg
    K&M 3.jpg
    61 KB · Views: 16
  • K&M 4.jpg
    K&M 4.jpg
    72.4 KB · Views: 19
  • K&M 5.jpg
    K&M 5.jpg
    53.6 KB · Views: 18
  • K&M 6.jpg
    K&M 6.jpg
    51.8 KB · Views: 18
Top