Rick Richard
Well-Known Member
Anyone have any experience with IMR 4166 in a 6.5 Creedmoor? Please share results and load data.
Thanks in advance.
Thanks in advance.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
IMR 4166 and 6.5 Creedmoor load data?
- Thread starter Rick Richard
- Start date
Help Support Long Range Hunting Forum
CBrowning
Active Member
Any luck? I just found out about this powder and searching myself.
coyotezapper
Well-Known Member
EricQ
New Member
Coytezapper...thanks for that link...I was looking for the same data as well.
If you have plenty go for it, but its been discontinued. All the enduron powder has been.
Seabeeken
Well-Known Member
I did a lot of testing with it and it was amazing in several cartridges but not the CM. I liked it so much that when they dropped it, I dropped hodgdon all together. Richard, I have 1 pound left if you are in my area of NW NC, its yours.
EricQ
New Member
I have 2lbs of it.
I gave the 4166 I had to a friend who couldn't find IMR 4064 for a couple of years. They are very close to each other in burn speed. Now he loves the stuff and it's to be no more. It just never caught on with America shooters. Still have some of the other enduron powders.
Seabeeken
Well-Known Member
Perhaps it was too good and was going to hurt their other powders. It sure shot amazing in most all my rifles. .5" or under and single digit es. 4451 was ok too but pressure peaked quickly. Didnt mess with the others much. 4166 shot so well i had no reason to.
Still have two or three pounds of 4451, and 8 pound jug of 4977. The 4977 is difficult to load because it goes from ok, to WTH really fast.
