Finally had some time to get list together: started with new RUGER receiver, Clark bull barrel, Kidd 2 stage trigger, Bushnell 6x18x50 scope with tactical rings,Boyd Barracuda stock. Sent receiver and barrel to Conecticut Precision Chambering, had barrel and receiver threaded to eliminate V block, barrel extractor groove recut, cut new recessed target crown, thread end of barrel with fitted tread protector, they supplied custom worked jeweled bolt/squared and dowel installed over firing pin to eliminate play, drilled and fitted picitanny rail. I did alot of grinding and fitting the stock to fit my hand and grip I felt that was best. I removed alot of wood to open up receiver, added redwood veneer to cheek piece and palm swell, cut new forearm opposite that you always see, mated new forearm end made from several hundred yr old Redwood root. Stock finished with approx. 50 coats of clear that was applied and sanded down till I got flat, no ripple smooth finish. I added a handmade Red & White pad spacer. Receiver is mated to stock, bedded in Devcon, brass pillar and stainless steel shoulder bolt to hold everything together. I can't get pictures downloaded, will keep trying.