Idaho Hunter1
Well-Known Member
Hello,
I'm looking for anyone that has had success or failure with the following setup. Looking for your load data, velocity, and groupings so I can build a mental model of what might work Or not. I appreciate everyone's help.
Hunting rifle with 26" barrel that currently shoots factory Nosler PT 180grn into about a .3-.4 group. Reloading because it's too expensive for shooting these factory loads long term when I can reload a similar round for significantly less.
ADG Brass
RL22 (I have other powders but want to try this one).
Bullets: Nosler PT 180grn /200grn; Barnes 175LRX; Federal 175grn Edge TLR (again, I have other bullets but want to try these specific ones so this or similar construction bullet data is appreciated).
I'm looking for anyone that has had success or failure with the following setup. Looking for your load data, velocity, and groupings so I can build a mental model of what might work Or not. I appreciate everyone's help.
Hunting rifle with 26" barrel that currently shoots factory Nosler PT 180grn into about a .3-.4 group. Reloading because it's too expensive for shooting these factory loads long term when I can reload a similar round for significantly less.
ADG Brass
RL22 (I have other powders but want to try this one).
Bullets: Nosler PT 180grn /200grn; Barnes 175LRX; Federal 175grn Edge TLR (again, I have other bullets but want to try these specific ones so this or similar construction bullet data is appreciated).
