270 speer 130gr. btsp Load data

Discussion in 'Reloading' started by clark270, Mar 17, 2014.

  1. clark270

    clark270 Well-Known Member

    Messages:
    154
    Joined:
    Feb 21, 2013
    I don't have a Speer data book and can't find this bullet on their website. Ok, I have federal 210 primers, Reminton & Federal brass, W760,Imr 4350, H4350 powders can anyone look up a min and max load for the speer 130gr. bullet for me? It's out of my Winchester M70 sporter 24" barrel.
     
  2. wogbg

    wogbg New Member

    Messages:
    2
    Joined:
    Feb 20, 2013
    Clark-- This from the #14 Speer manual--it does not account for your brass or primer-- all three of your powders are listed. 760-- 50 min.-54 max. H4350--52 min.- 56 max. IMR 4350--51 min.- 55max. The 760 used mag primer.--Bill
     
  3. Pa Grizz

    Pa Grizz Well-Known Member

    Messages:
    289
    Joined:
    Feb 8, 2014
    Thoughs are all good loads ,but the first thing I would do is decide what brass I would use.Federal brass is a little thicker than Remington.When you get close to max loads the pressure is differant.I found out the hard with a 270.Ihad been using Remington and not knowing better I loaded them up in federal and locked my rifle. So now I stick with one type of brass for each gun.The best load I have found with any 130 gr bt Speer, Sierra ,Nosler or Breger is 60 grs of h4831
     
  4. clark270

    clark270 Well-Known Member

    Messages:
    154
    Joined:
    Feb 21, 2013
    I will work up the load and watch for signs of too much pressure, thanks.