I have 8lb jug of unopened N570. I now have enough N570 and wanted to give the extra to someone else. I am looking to sell it for $395 face to face (cost of jug, hazmat, and shipping was more) . I am willing to meet within 1 hr of the Colorado Springs area. Please message if you have questions.
I have two unopened jugs of N570 that I am looking to trade for Retumbo. I am looking to save the life of my barrels a bit more so I have decided to go with Retumbo. I am not looking for cash, just an even 1 for 1 exchange and in person too. I live in the Colorado Springs area and I am willing...
Anyone run a 200 gr Accubond over N570 in their 300 rum? Looking for as much velocity with that bullet as I can safely get but still maintain good accuracy. Curious if anyone has played with that combo and what you found out?
For sale are an 8# jug of each N570 and N565. Both new and unopened. Picked these up recently for someone else, but they didn’t need them after all.
$350 each. Located in Post Falls, ID, and can’t ship. Please PM if interested.
Looking for any experience that you may have using n570 in the 338 ultra mag, specifically using 250 grain accubonds or 270 grain eld x. Not really a whole lot of data available, and if I’m going to burn n570 I want to reap the velocity benefit it provides. Thank you
I have a brand new 8# jug of N570 I'd like to trade for rifle primers. I can use small rifle, large rifle, and large rifle mag primers, and prefer CCI and Federal, with Federal Gold Medal most ideal.
Looking for 5 bricks of primers. I'm not using Gunbroker as a value basis for either the...
My 300 PRC is almost ready. I want to try 214gr Hammer Hunter with N570, H1000 and IMR 7828SSC. I want to get a starting point, first do a velocity/pressure test then start load development following the Berger book.
Does anyone have a load that could share? Please share barrel twist and...
Throwing this one out again. Trying to get a load for 285 ELDMs out of a 338 RUM with n570 powder. I’m shooting 250 berger elite hunters right now over 97 grains n570 in adg brass but would like some more energy and speed at distance. The load would be shot out of a factory Remington 700 xcr...
I reached out to Hornady and they don't have any reloading data, I'm still waiting on VV to get back to me; in the meantime what have you used as a starting point for a ladder test?
I have a 300WM, 28in barrel Krieger #5