tknuts103

Keep talking like that and I’m going to keep it.

Let Her Eat

I squeezed them together as hard as I could and there is still light between and could fit 3 pieces of paper between while fully compressed

Too close for comfort IMO. I'd leave the sight base alone and use slightly higher rings. If the comb is already a bit low, I'd try a...

I have sold all of my reflex sights as they aren't for me. Don't get me wrong, I have 2-7 scopes and they are alright but most people...

That's what I was thinking! I tried heating it up, putting a board against it, and hitting it but no go. Looks like it is staying

You’re probably right, may be a little adhesive. I think I would try a little heat, using a heat gun or similar. Not turning the thing...

Not pushed into a dovetail. The rear and front sight are both fixed without screws so must be some kind of adhesive. Hard to get a...

No screws holding it on. I already took off the part that is held on by screws. The last part is fused on somehow.. same as the front...

Awesome. Going to mount it down today and get it sighted in. Thanks for all of the help!

You should be fine.

Giter done!!

I see daylight.....let we rip tater chip!

As long as there is a gap you are fine Thanks Buck

my scope on my 338 NM is close like that, but at barrel, I can barely get factory cap on.Been like that ten years without issue