Recent content by texasgunner

Well I don't have a concentricity gage. I have a set of RCBS full length dies, also Redding neck die, and Redding comp. bullet seater, I know a little crazy, I came into them by various means

Have 22/250 in Savage Mod. 12 Shoots good now, but always looking for more accuracy

Would like some feed back on boards thoughts about com. dies (Redding esp.) Are they worth the money, verses regular dies, do they provide better accuracy

What tool do you use to trim, I have been using Lee's unit with the madrel that goes through the flash hole. I have tried Forrester's, not too crazy about it. Getting the set screw right is real pain. Anybody have other suggestions ?

Gentleman thanks, love this message board. Always guys here with good knowledge of subject!!!!

Ok, is it trial and error, I shoot a 22/250 from a Savage Mod. 12, shoots great, but always looking for better. Both mandrels use the same die?

Ok Guys, I really don't understand the use of a mandrel in sizing necks, I see an expander mandrel from 21 Century, why do you need to expand your neck, maybe someone can go through the process for me. HELP !!!

Ok guys, thanks for all the input, have another question. I shoot a 22-250 with neck angle of 28* What cutter angel do I want. Do not see a cutter with that angle.

Guys, thinking of getting into neck turning. Any advice on brands etc. K&M look good, but I know little about setup. Any help would be good.

Guys I thank you for your imput, you told me what I wanted to know

Ok guys, have question : Those of you that neck turn did it make a big difference in your groups, and does anybody use a reamer for the inside diameter, or do you only worry about the outside diameter

enter me in the Nikon Scope Contest

I would like to know what people think about Sierra's 180gr. boat tail for elk. I can push them to about 2900 fps.

I have a Sav Mod 12 with 1-9 twist, shoots Sierra 69 grs. extremely good. I am wondering if I can go up to the 80gr. and expect good accuracy. Anybody with a little experience ? If so what load ?

Thanks Guys , for the advice, sounds like very good advice, I will give it a try, I will bet it gets the job done. Thanks again....