Ive got a pretty good load for some 168 vlds and H-4350. Shoots under 1/2” quite easily. Ive been running into pressure more quickly than what I would think but just need to spend more time loading to get things dialed in.
If it has factory barrel you shouldn’t need to remove material to fit the B&C stock assuming the 7 prc has same barrel contour as a factory .30-06/.270. I wasnt able to use action screws from B&C because I changed the factory magazine over to a system from PT&G which uses bottom metal and AICS...
Its not feeding perfectly but with a little tinkering and polishing it should be good. I had to mill out parts of the stock to accommodate the bottom metal but I believe b&c makes bottom metal to accompany their short action stocks.
Definitely a huge improvement over the factory stock. It’s pretty sturdy and I prefer them over Boyds stocks. I believe Bell and Carlson and Boyds are the only companies who make a stock for the long action which is a shame.
Finally got this rifle all put together. Curious if anyone else has done similar.
Ruger American long action
Mcgowen 24” 1-8.5” 284 Win gap(long throat) barrel
Bell and carlson stock
Pacific tool and gauge bottom metal
Planning to build a load with 175 Berger Elite hunters and another with...
Ordered a McGowen 284 win gap barrel in a Shilen #5 contour 24” long 1-8.5 twist. Hoping to put it on a Ruger American LA .30-06 that I currently have. Planning to to put the action in a Bell and Carlson Medalist and inlet the stock to accept the PTG LA bottom metal for AICS. Probably not the...