Very Nice Goat!! I am heading to Colorado for them in a few weeks. Going to try to get them a little closer. I don't think my Mathews Traverse will stretch it that far!!!🤣🤣
Nice!!! You can't ask for a better shooting rifle than that! Doing a AR 10 build in 22 Creedmoor. Hopefully it shoots as good as my MPR. I know that's asking a lot out of a gas gun! I will update when I get my barrel and bolt from X-Caliber.
Hey all!! I just got some RL26 and was able to get the load my buddy had previously worked up for the 6.5 PRC that I bought off him. It is a Christensen Arms MPR. The load is:
55.8 grn of RL26
156 Berger EOL
Fed 210 primer
COL of 2.951
I had it zeroed in with factory Hornady 143 ELD-X and this...
Oh okay. I am looking at getting a 26" barrel built for that one. I just bought a Christensen MPR topped with that same scope chambered in 6.5 PRC. It weighs in at 10.4 lb.
Okay. I know it says on the site that they start with a McGowen Precision blank and go from there. Do you know about how much his barrel weighed before installation?
Hey All!
Looking at building a new light weight rifle with a 26 in or 28 in carbon fiber barrel. The only company that offers the right twist rate is Carbon Six. Has anyone ever used them?
They start with a McGowen Precision barrel then mill it down to your configurations and do the carbon fiber. Just was trying to see if anyone had used them.
Got a question for everyone. Have any of you used a Carbon Six barrel or know anything about them? I am looking at building a 27 Nosler in the next couple of months and trying to keep it under 9-10 lbs without ammo in it.
Hey all!! I am new to the forum and really liking all of the info. I am a backwoods country boy from Pa and just started about a 2 years ago shooting long range. There are parts on the way for a AR 10 22 Creedmoor build that I am stoked about getting a load worked up for it!! I found LRH by...