Recent content by Chris Terra

Give Brandon at El Sapo a call. Honest guy with a great personality. No pressure guide that works hard for you.

Give Tract optics a look.

Thanks. This is most likely the route I will take.

I did that with Redding and they have a 10-12 month wait. I'll try giving Wilson a call

Only standard die sets are available to load for the 6.5x300 Weatherby. I was hoping to use a bushing die and a micrometer seater to load as precise as possible but nothing is available. Other than settling for dies that are available and removing the size button and following up with a mandrel...

Take a look at Tract optics.

I've been reloading for several years from small pistol to large magnum rifle. I started on a Lee Classic Turret and that's what I still use for all of my rifle loads. It has served me ok but as they say, you start reloading and you shoot more. I'm no exception plus I can shoot over a thousand...

I bought a 6.5 x 300 Weatherby Mag at our local NRA dinner last summer. I sent it to Weatherby and had their Accubrake installed. I broke in the barrel with factory ammo loaded with Barnes. I must say, I really like shooting this gun. It's fast, flat, and accurate. Recoil is less than my 7 mag...

I load several handgun and rifle calibers. The 7mm rem mag is one of my favorite because it is my go to hunting gun. My 1:10 Ruger Mark II really likes the Barnes 140 TTSX over 69.2 of H1000. Killed lots of mule deer with that combo. Shoots right at 3000 fps

Most load data I can find has 869 as the "best" choice. What other would you recommend?

Fur friendly does not matter and I need to take my gun outta the box and measure the twist

New here so apologize if this posts twice. I'm in the process of gathering components to load for this new caliber of mine. I'm thinking of developing two loads. One with a heavier bullet for hunting and a lighter bullet for coyote\targets around the ranch. I'll be using US869 and maybe try...