Recent content by CapeEsperance

eye opening podcast! I have to rethink my approach.

Welcome from VA!

Cabelas in Gainesville VA has lots of ammo, no Primers. LGS in Warrenton VA has lots of ammo and based on walk through the other day selection of guns and gun stuff has matured (better selection of the right things) and came through shut down quite nicely. Unfortunately they are selling...

this

Welcome from Virginia!

Just picked up 2# H1000 at "Green Top" north of Richmond VA last week for $50 each (limit 2). Have been watching most suppliers hovering around 45-55 per pound for awhile now. limited selection of desired powders continues to be a challenge! Off to Dulles gun show to see what is available...

Thank you for passing it on to the next generation(s). At 65 I am earnestly doing the same with kids and grandkids. Very satisfying to see the multiplication. Also working with men, women, and kids at church! Passing on what I learned from Dad and others.

14 years old. M1Garand as part of junior shooting program. I have one of the NM versions we were shooting - I reload and periodically shoot it today.

i use an allen wrench to push the primers up above the cotter pin location. after this post, I will probably locate a more suitable wooden flat tipped stick to use in the future.

OP reporting static electricity is the only thng that makes sense to me during station assembly, or return to station after process interruption. one of the earlier posts had a video showing the process. stack of primers should not be near case being primed. You can see each primer prior to...

tagging in - i was thinking about buying one - this make more sense. thanks for the discussion of bolt grades!

thanks!

Apologies, but I am new to this, Ehat is a “stadia line”

What are "clickers" in this context. searched the forum and found several other 'items' called clickers, but nothing on this. many thanks...

was watching the comments on these stocks. after a less than satisfactory (poor QA) from another prominent vendor (finished stock) I bought a rosewood laminate from richard's microfit for my wife to replace factory plastic stock on a rem 700 vtr (.223). Agree the 99% finish was much rougher...