223 case length

6pakzak

Well-Known Member
Joined
Nov 30, 2021
Messages
678
Location
New York
What do you guys trim your 223 cases to, do you stay close to Max or min or in the middle, do you find accuracy improves if you go one way or the other, my 223 is savage walking varminter, any suggestions for factory rifle.
 
What do you guys trim your 223 cases to, do you stay close to Max or min or in the middle, do you find accuracy improves if you go one way or the other, my 223 is savage walking varminter, any suggestions for factory rifle.
I trim all my .223 win cases to 1.75" min length. I run them through my Henderson 3 in 1 trimmer every reload just to keep consistent.
 
I have been trimming to 1.75, figured it's a good middle ground but for my 6.5 creed I decided to trim it back about .010 from my usual length and my groups improved so now I'm sticking with that, I thought if the neck is shorter it would have less influence on bullet exiting case, I'm probably totally wrong about that, may just work better in that rifle, so I would ask Buck if you always trimmed to minimum or did you notice your rifle shooting better that way, I kinda cringe at trimming to minimum but I should probably give it a try.
 
Maybe I should stick with standard, just wondering if anybody noticed a difference, maybe I'll try it on brass I kept from cheap ammo when it used to be cheap, pic out the best ones
 
If you are using cheap brass you can trim chamfer and deburr then weight sort the cases. That way you can batch up brass with similar capacities. It will help a little on your SDs.
 
I tried to look into other forums and one guy said cutting short would cause throat erosion, anyone agree with this?
 
1.75 here too. The grandson's Ruger bolt in .223 is very accurate with Nosler brass and Varget.
 
Throat erosion no, carbon build up from being too short maybe. Unless your chamber is very long relative to the min-case trim length then my opinion is that's not something to worry about.

Anyways, trimming. If you're mixing brass then yes, size it, trim it back, run it.

If you have a nice single-lot batch of matched brass that you take care of, then buy a bore scope, run it down, look at where you actually are with a few cases, and trim cases consistently across the lot to the length your chamber needs. I don't think it'll make a big difference either way you do it, but I try to practice loading skills on easy cartridges so that hard cartridges go more smoothly down the road. 223 is an easy cartridge to practice on because it's cheap, yet has great potential at the same time.
 

Recent Posts

Top