Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What would cause this
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Lee Goodwin" data-source="post: 2084027" data-attributes="member: 107289"><p>So you are resizing the brass , priming it, then putting it in the chamber and getting these marks, and it is tight.? I would check the shoulder to see if it is mushroomed from the FL die. If you crushed the shoulder a little it could cause tightness on bolting. Looks like your primer sticks out too far. I would start all over and make sure you don't set the shoulder back too far and set the primer flush.</p></blockquote><p></p>
[QUOTE="Lee Goodwin, post: 2084027, member: 107289"] So you are resizing the brass , priming it, then putting it in the chamber and getting these marks, and it is tight.? I would check the shoulder to see if it is mushroomed from the FL die. If you crushed the shoulder a little it could cause tightness on bolting. Looks like your primer sticks out too far. I would start all over and make sure you don't set the shoulder back too far and set the primer flush. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What would cause this
Top