Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
using action screws to bed stock?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Clark" data-source="post: 933915" data-attributes="member: 6600"><p>I have only done one Rem700 pillar bed job, but here is how I did it.</p><p>I made pillars from 1/2" 6061 round stock.</p><p>I used a boring head to get a concave radius to match the 1.355" receiver diameter. I actually made the radius a little small, so the pre compression would open the pillar to 1.355" diameter.</p><p>I cut grooves on the sides of the pillar for the epoxy to grip better.</p><p></p><p>I put Devcon steel putty on the pillars and strapped the barreled receiver to the Bansner stock. I did the recoil lug bedding later.</p></blockquote><p></p>
[QUOTE="Clark, post: 933915, member: 6600"] I have only done one Rem700 pillar bed job, but here is how I did it. I made pillars from 1/2" 6061 round stock. I used a boring head to get a concave radius to match the 1.355" receiver diameter. I actually made the radius a little small, so the pre compression would open the pillar to 1.355" diameter. I cut grooves on the sides of the pillar for the epoxy to grip better. I put Devcon steel putty on the pillars and strapped the barreled receiver to the Bansner stock. I did the recoil lug bedding later. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
using action screws to bed stock?
Top