Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Ultimate Tripod questions..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jake in NC" data-source="post: 43748" data-attributes="member: 878"><p>.. Well, I did the 5/16-18 conversion tonight.. All I had to remove was the coating in the slot for the most part.. The hole in the bracket and bottom were just a matter of drilling them to 5/16.. Still, there was very little metal actually removed.. I went to snag one of the threaded thru knobs on Sandy's quilting rack but they were a little too cheesy for the job at hand. (Much to her relief.) I guess a trip to Automotive Fastners is at hand.. </p><p>.. Anyhow.. Ya think there may be enough interest in this process to make a web page.? d:^) JiNC</p></blockquote><p></p>
[QUOTE="Jake in NC, post: 43748, member: 878"] .. Well, I did the 5/16-18 conversion tonight.. All I had to remove was the coating in the slot for the most part.. The hole in the bracket and bottom were just a matter of drilling them to 5/16.. Still, there was very little metal actually removed.. I went to snag one of the threaded thru knobs on Sandy's quilting rack but they were a little too cheesy for the job at hand. (Much to her relief.) I guess a trip to Automotive Fastners is at hand.. .. Anyhow.. Ya think there may be enough interest in this process to make a web page.? d:^) JiNC [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Ultimate Tripod questions..
Top