Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
TURNING CASE NECKS?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Buffalobob" data-source="post: 129174" data-attributes="member: 8"><p>Three suggestions</p><p></p><p>1. It will help your neck turning a lot if you don't make your posts in all caps.</p><p></p><p>2. Use old brass to practice on. The necks will be harder but when you ruin the brass it's loss will be less.</p><p></p><p>3. You will or should notice that one side of the cutter blade is whacked off. This is not a manufacturing defect as I assumed. It is actually the side of the blade that intersects with the shoulder. Some people say that if you take just a litle nick out of the junction that it will prevent doughnuts. I suspect that this is much like rubbing a wart with a new penny and burying it with a potato under the full moon. /ubbthreads/images/graemlins/grin.gif</p><p></p><p>CAUTION: The surgeon general warns that neck turning is hazardous to your mental health. I actually turned some 17 Rem brass a little too much and the neck was too thin to get squeezed down by the resizing die and would not hold a bullet.</p></blockquote><p></p>
[QUOTE="Buffalobob, post: 129174, member: 8"] Three suggestions 1. It will help your neck turning a lot if you don't make your posts in all caps. 2. Use old brass to practice on. The necks will be harder but when you ruin the brass it's loss will be less. 3. You will or should notice that one side of the cutter blade is whacked off. This is not a manufacturing defect as I assumed. It is actually the side of the blade that intersects with the shoulder. Some people say that if you take just a litle nick out of the junction that it will prevent doughnuts. I suspect that this is much like rubbing a wart with a new penny and burying it with a potato under the full moon. [img]/ubbthreads/images/graemlins/grin.gif[/img] CAUTION: The surgeon general warns that neck turning is hazardous to your mental health. I actually turned some 17 Rem brass a little too much and the neck was too thin to get squeezed down by the resizing die and would not hold a bullet. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
TURNING CASE NECKS?
Top