Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Turn necks on virgin brass?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Plowboy85" data-source="post: 1796332" data-attributes="member: 66137"><p>I think it's odd anyone would turn after fireforming unless you found after the fireforming that you needed to perform it. I can't see what good it does to turn the neck after the chamber forms it, you will still need to run it over a mandrel to push the imperfections out or you will not clean the brass up uniformly. In some cases of new brass I have had to size then use an expanding mandrel to set up for turning.</p></blockquote><p></p>
[QUOTE="Plowboy85, post: 1796332, member: 66137"] I think it’s odd anyone would turn after fireforming unless you found after the fireforming that you needed to perform it. I can’t see what good it does to turn the neck after the chamber forms it, you will still need to run it over a mandrel to push the imperfections out or you will not clean the brass up uniformly. In some cases of new brass I have had to size then use an expanding mandrel to set up for turning. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Turn necks on virgin brass?
Top