Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To bush or mandrel
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RD57" data-source="post: 2130551" data-attributes="member: 103010"><p>My bushing dies are retired, the most consistent brass results with minimal runout have been with FL dies with honed necks, normal FL dies with expander mandrels in a later step or FL dies with an expander as close to the neck sizing part of the die similar to what Forster uses so the neck goes over the expander as it is guided by the neck sizing part of the die. The later works extremely well with neck turned brass that only requires about a .001 - .0005 bump up.</p></blockquote><p></p>
[QUOTE="RD57, post: 2130551, member: 103010"] My bushing dies are retired, the most consistent brass results with minimal runout have been with FL dies with honed necks, normal FL dies with expander mandrels in a later step or FL dies with an expander as close to the neck sizing part of the die similar to what Forster uses so the neck goes over the expander as it is guided by the neck sizing part of the die. The later works extremely well with neck turned brass that only requires about a .001 - .0005 bump up. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To bush or mandrel
Top