Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Tikka actions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Roughrice" data-source="post: 2754755" data-attributes="member: 118657"><p>How far off the end of the receiver (tenon area) do you clamp down the two flat sided wheeler wrench?</p><p>It seems like it would put uneven stress on opposite side flats and bind the threads?</p><p>Also… do you set up at 90 degrees to an upright receiver as not to touch the top rail?</p><p></p><p>I've been lucky on my previous Tikka with the rear entry but this one is a tiger!</p><p></p><p>Any additional information would be helpful.</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="Roughrice, post: 2754755, member: 118657"] How far off the end of the receiver (tenon area) do you clamp down the two flat sided wheeler wrench? It seems like it would put uneven stress on opposite side flats and bind the threads? Also… do you set up at 90 degrees to an upright receiver as not to touch the top rail? I’ve been lucky on my previous Tikka with the rear entry but this one is a tiger! Any additional information would be helpful. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Tikka actions
Top