Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sizing Die Adjustment - Needed??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="sedancowboy" data-source="post: 1288829" data-attributes="member: 85874"><p>Everyone else has tried to solve your problem so let me try. The Redding shell holders mentioned above start at +.002-+.010 not negative so that would make his problem worse not better. A regular shell holder is .125 from base of shell to top of shell holder which touches the die. He needs to take away from that not add to. So I would place a fine sheet of sand paper on a flat surface and turn the shell holder upside down and sand off .002-.004 and try it I will bet that he will be able to get the case into the die far enough to set the shoulder back and fit his S&W rifle. Assuming you run it up touching the die after the press toggles over. It that works problem solved use that shell holder with that set of dies for that gun. If it don't then you have to buy a new shell holder about 6-7 bucks.</p></blockquote><p></p>
[QUOTE="sedancowboy, post: 1288829, member: 85874"] Everyone else has tried to solve your problem so let me try. The Redding shell holders mentioned above start at +.002-+.010 not negative so that would make his problem worse not better. A regular shell holder is .125 from base of shell to top of shell holder which touches the die. He needs to take away from that not add to. So I would place a fine sheet of sand paper on a flat surface and turn the shell holder upside down and sand off .002-.004 and try it I will bet that he will be able to get the case into the die far enough to set the shoulder back and fit his S&W rifle. Assuming you run it up touching the die after the press toggles over. It that works problem solved use that shell holder with that set of dies for that gun. If it don't then you have to buy a new shell holder about 6-7 bucks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sizing Die Adjustment - Needed??
Top