Seekins Precsision Scope Rings

[Gregt9146]

Im looking at buy a set of scope rings but don't know anything about them. Does anyone have any experience using them on their rifles, opinions good, bad, indifferent?

 

[Lumbeejake]

Seekins makes good stuff.

 

[Rockin90]

I have used them on several rifles and just ordered more to mount a new scope. I highly recommend them.

 

[sedancowboy]

Great rings at a good price. Precision at its finest.

 

[Gregt9146]

perfect thanks

 

[Idaho5r]

Yes the Seekins Precision, & also the Vortex PMR (rebranded Seekins) rings are very Good in my opinion!!! I have several sets of them, & have NO problems with them. Robust, & very well made!!!!!!

 

[Mike D Texas]

What size are you looking for and what height? I'm changing my s stuff over to ARC rings and may have a couple sets for sale and could save you $$ over new.

 

[valsport05]

Timely subject following as well

 

[Gregt9146]

34MM not sure on height Med or high probably as the scope will have a 52mm bell going on a christianson arms ridgeline rifle

 

[Mike D Texas]

34MM not sure on height Med or high probably as the scope will have a 52mm bell going on a christianson arms ridgeline rifle

I probably have exactly what you need. This is a VX6 4-24x52 with Seekins low rings mounted on a 20MOA rail. The rifle has been sold but I kept the rings and scope to move to its replacement. I'm considering replacing these rings with ARC rings.

If interested PM me.

 

[gpo1956]

Lows would possibly work, but mediums would be safest. Unless there are unusual circumstances you should probably avoid highs.

 

[brcfo_outdoors]

Seekins are good, but if you are shelling out for good rings, the ARC M10's are better. Simpler to install and keep your reticle level while being of equivalent quality and craftsmanship. They also have a guide on their website to help you choose the right height.

 

[Rob01]

Been using Seekins rings since 2005 and never let down. They do what they should in holding the scope solid to the action. I like not having a nut on the side of the rings also.

For my 56mm scopes I use 1" high 34mm rings. 50mm can use the .92" height without a problem.Below is 1" high and 56mm and a med palma contour barrel. Will work with heavier contours too.

This is a Proof comp contour which is heavier than any factory rifle and 1" works there too.

Here is a set of 1.26" height with 56mm objective on a Surgeon action with integral base, so lower than an attached base, and an M24/40 contour barrel. I went with the 1.26" on this one as with the other barrel I have for this rifle the 1" had the scope cap touching with the lower height of the integral base.

 

[Mschroeder40]

Can't go wrong with Seekins!