Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Scope failed tall target test....🤬
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DocGlenn" data-source="post: 1926804" data-attributes="member: 5122"><p>So I have a Leupold VX6 on my CA 6.5 PRC. Rifle shoots really well, I've got a load worked up that is consistent and I'm feeling good about this fall until the tall target test. When I dial up, I get a 1.5-2" shift to the right. I ran the test 4 times. Made sure the target was plumb with a level, used levels to mount the scope, and even tried rotating the scope counter clockwise (since the shift was to the right). Nothing has worked. No matter what I try, when I dial up, I get a POI shift to the right. I know there are a lot of things that can cause this. I'm using Talley one piece rings for the mount. I've remounted the scope twice. I've got a NF I'm going to put on it to see if it is the scope or the mounts, or the receiver. Anyone have any other suggestions? Would a bore sighting tool show the discrepancy?? I got the scope from Holland's with his reticle in it. I'm going to call them on Monday to see what they have to say. Is it possible I just have a bad scope?? Thanks. </p><p>Glenn</p></blockquote><p></p>
[QUOTE="DocGlenn, post: 1926804, member: 5122"] So I have a Leupold VX6 on my CA 6.5 PRC. Rifle shoots really well, I’ve got a load worked up that is consistent and I’m feeling good about this fall until the tall target test. When I dial up, I get a 1.5-2” shift to the right. I ran the test 4 times. Made sure the target was plumb with a level, used levels to mount the scope, and even tried rotating the scope counter clockwise (since the shift was to the right). Nothing has worked. No matter what I try, when I dial up, I get a POI shift to the right. I know there are a lot of things that can cause this. I’m using Talley one piece rings for the mount. I’ve remounted the scope twice. I’ve got a NF I’m going to put on it to see if it is the scope or the mounts, or the receiver. Anyone have any other suggestions? Would a bore sighting tool show the discrepancy?? I got the scope from Holland’s with his reticle in it. I’m going to call them on Monday to see what they have to say. Is it possible I just have a bad scope?? Thanks. Glenn [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Scope failed tall target test....🤬
Top