Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
resize necks after pulling bullets?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Greyfox" data-source="post: 885157" data-attributes="member: 10291"><p>For me, it depends on the specific rifle, load, and use. There are a few factors for consideration like whether the brass is near needing to be annealed, and the felt seating tension of load, before and after. If it is a whole batch that needs to be pulled and my use is for match, or LR hunting, I'll resize all of them to be sure the seating tension is consistent. If it's one or two, I'll just load them without resizing and note them for use as fouling shots. I have rarely, if ever seen much difference in groups at 100 or 200 hundred yards, but with some rifles/loads I have seen differences in ES with pulled brass that hasn't been resized. For serious work, I'll always opt for peace of mind. The other thing to note is the condition of pulled bullets, and whether they were in any way deformed during the removal process. IMO.</p></blockquote><p></p>
[QUOTE="Greyfox, post: 885157, member: 10291"] For me, it depends on the specific rifle, load, and use. There are a few factors for consideration like whether the brass is near needing to be annealed, and the felt seating tension of load, before and after. If it is a whole batch that needs to be pulled and my use is for match, or LR hunting, I'll resize all of them to be sure the seating tension is consistent. If it's one or two, I'll just load them without resizing and note them for use as fouling shots. I have rarely, if ever seen much difference in groups at 100 or 200 hundred yards, but with some rifles/loads I have seen differences in ES with pulled brass that hasn't been resized. For serious work, I'll always opt for peace of mind. The other thing to note is the condition of pulled bullets, and whether they were in any way deformed during the removal process. IMO. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
resize necks after pulling bullets?
Top