deadnbrkn84
Well-Known Member
I have:
Remington 300 Saum Brass
252 - Necked down to 6.5 - Not Turned Yet. Factory Primed.
123 - Necked down, turned, and fired once.
21 - Necked down, turned, not fired.
396 - Total
These were necked down properly, with two different size bushings, then ran a 6.5 mandrel through them. The ones that were turned were done to 14.5 thou. I also have the 21st Century Neck turning lathe that I will be selling with this or once it's all sold. That this brass was used on. Lathe will come with 20° and 30° cutters and the 6.5 mandrel and die. This all retails at $350. Would be looking for around $260 out of it.
All the brass - $420 shipped.
21st Lathe with accessories - $260 shipped.
All the brass and lathe - $650 shipped.
Remington 300 Saum Brass
252 - Necked down to 6.5 - Not Turned Yet. Factory Primed.
123 - Necked down, turned, and fired once.
21 - Necked down, turned, not fired.
396 - Total
These were necked down properly, with two different size bushings, then ran a 6.5 mandrel through them. The ones that were turned were done to 14.5 thou. I also have the 21st Century Neck turning lathe that I will be selling with this or once it's all sold. That this brass was used on. Lathe will come with 20° and 30° cutters and the 6.5 mandrel and die. This all retails at $350. Would be looking for around $260 out of it.
All the brass - $420 shipped.
21st Lathe with accessories - $260 shipped.
All the brass and lathe - $650 shipped.
