Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remington 700 magazine feed lip tool??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1751003" data-attributes="member: 2736"><p>I made mine using a piece of 1/4 " flat bar 2" wide 4" long.i also used a portaband to cut the slot.</p><p></p><p>It is strong enough but thin enough to do the job. Using a gray Marker pin I place marks on the top edge of the lips every 1/2" and then using the vernier caliper, I measure the spacing before I start bending. this way I can tell how much bending/adjusting I need to get the results wanted.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1751003, member: 2736"] I made mine using a piece of 1/4 " flat bar 2" wide 4" long.i also used a portaband to cut the slot. It is strong enough but thin enough to do the job. Using a gray Marker pin I place marks on the top edge of the lips every 1/2" and then using the vernier caliper, I measure the spacing before I start bending. this way I can tell how much bending/adjusting I need to get the results wanted. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remington 700 magazine feed lip tool??
Top