Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
reloading question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Remtac" data-source="post: 1281993" data-attributes="member: 99283"><p>i just ordered the redding big boss2 press with typ S full bushing die and competition seating die now when i read these instructions from the redding website for headspacing ( To do so, raise the ram of your reloading press to the top position with the shellholder installed. Take your full length sizing die and screw it down to the point where it's touching the shellholder. Now back off the die by about a half turn.) </p><p></p><p>my question is what is a half turn ? to me a full turn is 360 degree and a half turn would be 180 degree with the die , is this correct ?</p></blockquote><p></p>
[QUOTE="Remtac, post: 1281993, member: 99283"] i just ordered the redding big boss2 press with typ S full bushing die and competition seating die now when i read these instructions from the redding website for headspacing ( To do so, raise the ram of your reloading press to the top position with the shellholder installed. Take your full length sizing die and screw it down to the point where it's touching the shellholder. Now back off the die by about a half turn.) my question is what is a half turn ? to me a full turn is 360 degree and a half turn would be 180 degree with the die , is this correct ? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
reloading question
Top