Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Release agent for glass bedding??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="NEMTHunter" data-source="post: 1673700" data-attributes="member: 77631"><p>I would not tighten them up at all. If you put to much pressure you can warp the action and that would defeat the purpose of glass bedding. I would either just get it snug. Another way I like to do it is to used studs and just use rubber bands to hold the action in place or tape. That way you are sure not to over tighten it.</p><p></p><p>As for filling the forarm, I plan on just using Epoxy in mine.</p></blockquote><p></p>
[QUOTE="NEMTHunter, post: 1673700, member: 77631"] I would not tighten them up at all. If you put to much pressure you can warp the action and that would defeat the purpose of glass bedding. I would either just get it snug. Another way I like to do it is to used studs and just use rubber bands to hold the action in place or tape. That way you are sure not to over tighten it. As for filling the forarm, I plan on just using Epoxy in mine. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Release agent for glass bedding??
Top