Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reducing Bolt Diameter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="25WSM" data-source="post: 1756778" data-attributes="member: 38048"><p>My lathe will take less than .003 and leave a nice finish. Turn the speed up and the feed down. Use a good cutting fluid. I do this on my crowns and on the 30 degree cone on the chamber end and don't even have to sand them. If your not sure you can do it just use sandpaper. Doesn't take much to drop .003</p><p>Shep</p></blockquote><p></p>
[QUOTE="25WSM, post: 1756778, member: 38048"] My lathe will take less than .003 and leave a nice finish. Turn the speed up and the feed down. Use a good cutting fluid. I do this on my crowns and on the 30 degree cone on the chamber end and don't even have to sand them. If your not sure you can do it just use sandpaper. Doesn't take much to drop .003 Shep [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reducing Bolt Diameter
Top